Rainbow-electronics ATtiny861_V Instrukcja Użytkownika Pobierz pdf (Strona 177)

177

2588B–AVR–11/06

ATtiny261/461/861

Figure 22-4. Programming the EEPROM Waveforms

22.7.6 Reading the Flash

The algorithm for reading the Flash memory is as follows (refer to ”Programming the Flash” on

page 174 for details on Command and Address loading):

1. A: Load Command “0000 0010”.

2. G: Load Address High Byte (0x00 - 0xFF).

3. B: Load Address Low Byte (0x00 - 0xFF).

4. Set OE

to “0”, and BS1 to “0”. The Flash word low byte can now be read at DATA.

5. Set BS to “1”. The Flash word high byte can now be read at DATA.

6. Set OE

to “1”.

22.7.7 Reading the EEPROM

The algorithm for reading the EEPROM memory is as follows (refer to ”Programming the Flash”

on page 174 for details on Command and Address loading):

1. A: Load Command “0000 0011”.

2. G: Load Address High Byte (0x00 - 0xFF).

3. B: Load Address Low Byte (0x00 - 0xFF).

4. Set OE

to “0”, and BS1 to “0”. The EEPROM Data byte can now be read at DATA.

5. Set OE

to “1”.

22.7.8 Programming the Fuse Low Bits

The algorithm for programming the Fuse Low bits is as follows (refer to ”Programming the Flash”

on page 174 for details on Command and Data loading):

1. A: Load Command “0100 0000”.

2. C: Load Data Low Byte. Bit n = “0” programs and bit n = “1” erases the Fuse bit.

3. Give WR

a negative pulse and wait for RDY/BSY to go high.

RDY/BSY

RESET +12V

0x11 ADDR. HIGH

DATA

ADDR. LOW DATA ADDR. LOW DATA XX

XA1/BS2

XA0

PAGEL/BS1

XTAL1

AGBCEB C EL

1 2 ... 172 173 174 175 176 177 178 179 180 181 182 ... 235 236

Brak uwag

Rainbow-electronics ATtiny861_V Instrukcja Użytkownika Strona 177