Rainbow-electronics MAX1201 Instrukcja Użytkownika Pobierz pdf

MAX1201

+5V Single-Supply, 2.2Msps, 14-Bit

Self-Calibrating ADC

________________________________________________________________

Maxim Integrated Products

For free samples & the latest literature: http://www.maxim-ic.com, or phone 1-800-998-8800.

For small orders, phone 1-800-835-8769.

General Description

The MAX1201 is a 14-bit, monolithic, analog-to-digital

converter (ADC) capable of conversion rates up to

2.2Msps. This integrated circuit, built on a CMOS

process, uses a fully differential, pipelined architecture

with digital error correction and a short self-calibration

procedure that corrects for capacitor and gain mis-

matches and ensures 14-bit linearity at full sample rates.

An on-chip track-and-hold (T/H) maintains superb

dynamic performance up to the Nyquist frequency. The

MAX1201 operates from a single +5V supply.

The fully differential inputs allow an input swing of

±VREF. A single-ended input is also possible using two

operational amplifiers. The reference is also differential

with the positive reference (RFPF) typically connected

to +4.096V and the negative reference (RFNF) tied to

analog ground. Additional sensing pins (RFPS, RFNS)

are provided to compensate for any resistive divider

action that may occur due to finite internal and external

resistances.

The power dissipation is typically only 269mW at +5V

and a sampling rate of 2.2Msps. The device employs a

CMOS compatible, 14-bit parallel, two’s complement out-

put data format. The MAX1201 is available in a 44-pin

MQFP package and is specified over the commercial

temperature (0°C to +70°C) and extended (-40°C to

+85°C) temperature ranges.

Applications

xDSL

Instrumentation

Medical Imaging

Scanners

IR Imaging

Spectrum Analysis

Features

♦ Monolithic 14-Bit, 2.2Msps ADC

♦ Signal-to-Noise Ratio of 83dB

♦ Spurious-Free Dynamic Range of 91dB

♦ Differential Nonlinearity Error: ±0.3LSB

♦ Integral Nonlinearity Error: ±1.2LSB

♦ Single +5V Analog Supply, +3V Digital Supply

♦ Low Power Dissipation: 269mW

♦ On-Demand Self-Calibration

♦ Three-State, Two’s Complement Output Data

DAV

CLK

DGND

TEST1

TEST2

TEST3

ST_CAL

AGND

DOR

D13

D12

D11

D10

DRV

DGND

END_CAL

INN

N.C.

INP

RFNS

RFNF

RFPS

RFPF

TEST0

TOP VIEW

MQFP

MAX1201

19-4776; Rev 1; 11/98

PART TEMP. RANGE PIN-PACKAGE

Ordering Information

Pin Configuration

MAX1201CMH

MAX1201EMH -40°C to +85°C

0°C to +70°C 44 MQFP

44 MQFP

EVALUATION KIT

AVAILABLE

1 2 3 4 5 6 ... 15 16

Podsumowanie treści

Strona 1 - Self-Calibrating ADC

MAX1201+5V Single-Supply, 2.2Msps, 14-Bit Self-Calibrating ADC________________________________________________________________Maxim Integrated Product

Strona 2

MAX1201+5V Single-Supply, 2.2Msps, 14-Bit Self-Calibrating ADC10 _____________________________________________________________________________________

Strona 3

MAX1201+5V Single-Supply, 2.2Msps, 14-Bit Self-Calibrating ADC______________________________________________________________________________________ 1

Strona 4

MAX1201+5V Single-Supply, 2.2Msps, 14-Bit Self-Calibrating ADC12 _____________________________________________________________________________________

Strona 5

MAX1201+5V Single-Supply, 2.2Msps, 14-Bit Self-Calibrating ADC______________________________________________________________________________________ 1

Strona 6

MAX1201+5V Single-Supply, 2.2Msps, 14-Bit Self-Calibrating ADC14 _____________________________________________________________________________________

Strona 7

MAX1201+5V Single-Supply, 2.2Msps, 14-Bit Self-Calibrating ADC______________________________________________________________________________________ 1

Strona 8

MAX1201+5V Single-Supply, 2.2Msps, 14-Bit Self Calibrating ADCMaxim cannot assume responsibility for use of any circuitry other than circuitry entirel

Strona 9

MAX1201+5V Single-Supply, 2.2Msps, 14-Bit Self-Calibrating ADC2 ______________________________________________________________________________________

Strona 10

MAX1201+5V Single-Supply, 2.2Msps, 14-Bit Self-Calibrating ADC_______________________________________________________________________________________

Strona 11

MAX1201+5V Single-Supply, 2.2Msps, 14-Bit Self-Calibrating ADC4 ______________________________________________________________________________________

Strona 12

MAX1201+5V Single-Supply, 2.2Msps, 14-Bit Self-Calibrating ADC_______________________________________________________________________________________5

Strona 13

MAX1201+5V Single-Supply, 2.2Msps, 14-Bit Self-Calibrating ADC6 ______________________________________________________________________________________

Strona 14

MAX1201+5V Single-Supply, 2.2Msps, 14-Bit Self-Calibrating ADC_______________________________________________________________________________________

Strona 15

MAX1201+5V Single-Supply, 2.2Msps, 14-Bit Self-Calibrating ADC8 ______________________________________________________________________________________

Strona 16 - Self Calibrating ADC

MAX1201+5V Single-Supply, 2.2Msps, 14-Bit Self-Calibrating ADC_______________________________________________________________________________________

Komentarze do niniejszej Instrukcji

Brak uwag

Rainbow-electronics MAX1201 Instrukcja Użytkownika

Przeglądaj online lub pobierz Instrukcja Użytkownika dla Czujniki Rainbow-electronics MAX1201. Rainbow Electronics MAX1201 User Manual Instrukcja obsługi

Podsumowanie treści

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Czujniki Rainbow-electronics MAX1201