
www.EZURiO.com
DSH_BTM402_0v9 BISM2 PA Data Sheet.DOC © 2007 EZURiO Ltd
13
• Remotely access the AT parser of the remote unit from a master device to perform Over The
Air (OTA) configuration.
Configure the modul
• e to enter a state on power up and after a period of time change to
This allows units to be placed in the discoverable state for a
• Read the ADC channels
t fast d ADC status through an inquiry response (patent pending)
7.3.1.2
• Set up audio connections
able Auto Answer for incoming connections
7.3.1.3
character
• Change the number of Stop bits and Parity
able hoes
7.3.1.4
• ncoming AND / OR outgoing connections
• Enable coming AND / OR outgoing connections. The
module
ble,
le,
connectable and discoverable.
aired devices in a trusted device database in the flash memory
7.3.1.5
es
mote device
before the master abandons a connection attempt
• Change number of returned devices from an inquiry scan
tain t ction
7.3.1.6
• Decrease or increase the output power to suit your connection range
• Configure the modules to work in Sniff and other low power modes.
another state automatically.
limited time period.
• Read and write to GPIO lines
• Ge GPIO an
Audio
• En / disable
UART
• Change the baud rate from 1200 to 921,600 baud.
• Use the DSR line to drop connections
• Flexible configuration as either DTE or DCE
• Change escape sequence
• En or disable ec
Security
Enable Authentication by requiring a PIN code for i
data to be encrypted over the air for in
can be configured to be:
non-connectable and non-discovera
non-connectable but discoverab
connectable but non-discoverable,
• Automatically store P
Bluetooth
• Set the module to be a master or slave
• Make a Bluetooth connection to a specified device
• Perform a full inquiry for other Bluetooth devic
• Query a remote device to check if a service is offered
• Fetch the friendly name of a re
• Increase or decrease the delay
• Change the device class code
• Set the device’s friendly name
• Change the Inquiry scan time
• Ob he RSSI value for a conne
Power Management
Komentarze do niniejszej Instrukcji