Rainbow-electronics ATtiny10 Instrukcja Użytkownika Pobierz pdf (Strona 34)

8127B–AVR–08/09

ATtiny4/5/9/10

• Bits 2:0 – VLM2:0: Trigger Level of Voltage Level Monitor

These bits set the trigger level for the voltage level monitor, as described in Table 8-4 below.

For VLM voltage levels, see TBD, TBD and TBD.

8.4.3 RSTFLR – Reset Flag Register

The Reset Flag Register provides information on which reset source caused an MCU Reset.

• Bits 7:4, 2– Res: Reserved Bits

These bits are reserved bits in ATtiny4/5/9/10 and will always read as zero.

• Bit 3 – WDRF: Watchdog Reset Flag

This bit is set if a Watchdog Reset occurs. The bit is reset by a Power-on Reset, or by writing a

logic zero to the flag.

• Bit 1 – EXTRF: External Reset Flag

This bit is set if an External Reset occurs. The bit is reset by a Power-on Reset, or by writing a

logic zero to the flag.

• Bit 0 – PORF: Power-on Reset Flag

This bit is set if a Power-on Reset occurs. The bit is reset only by writing a logic zero to the flag.

To make use of the Reset Flags to identify a reset condition, the user should read and then reset

the MCUSR as early as possible in the program. If the register is cleared before another reset

occurs, the source of the reset can be found by examining the Reset Flags.

Table 8-4. Setting the Trigger Level of Voltage Level Monitor.

VLM2:0 Label Description

000 VLM0 Voltage Level Monitor disabled

001 VLM1L

Triggering generates a regular Power-On Reset (POR).

The VLM flag is not set

010 VLM1H

011 VLM2

Triggering sets the VLM Flag (VLMF) and generates a VLM

interrupt, if enabled

100 VLM3

101

Not allowed110

111

Bit 76543210

0x3B

– – – – WDRF – EXTRF PORF RSTFLR

Read/Write R R R R R/W R R/W R/W

Initial Value 0 0 0 0 X 0 X X

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 165 166

Brak uwag

Rainbow-electronics ATtiny10 Instrukcja Użytkownika Strona 34